Our professional pollen catcher trap has the advantage that it can be applied to virtually all existing Beehives, even those that have an entrance from above, and very easily. By attaching two different sheet metal canopies that protect it from the rain on the top, two different planes of support on the wall are created, and it can be applied to STANDARD Beehives with the porch (item LA 2405) and to KUBIK Beehives (item LA 2407). The trap rests on the step and is quickly attached to the front wall of the Beehive with two eye screws in prepared slots. The two clear plastic tubes inserted on either side of the trap are exactly level with the base net and facilitate cleaning by the bees. The "pollen peeler" grid is made of plastic, has only three horizontal rows of round holes and special longitudinal brackets at the base of the holes on which the bees rest before passing through the holes and losing the pollen pellets. The base net, on which the pollen falls before ending up in the box measures 90x360 mm and is made of AISI 304 stainless steel. On the top of the vertical wall supporting the grid are 6 transparent plastic cones with the tips pointing outward, which function as a one-way exit for drones and bees, but are not recognized by the bees as an entrance. The pollen collector drawer has a bottom made of AISI 304 stainless steel mesh, has a large size (330x90x110 mm) with a capacity of about 3300 cm³, and is pulled out by sliding it on two metal guides. (The average yield on a good day can exceed 500 grams.) The galvanized sheet metal canopy protrudes forward and protects the pollen contained in the drawer from rain.